Free quote and on-site load calculation.
We install Level 2 chargers, Tesla Wall Connectors and panel upgrades.
Level 2 install: $1,200 to $2,500. Typical for a charger 20 to 40 feet from the panel, with labor, materials and permit.
A permit on every charger. Livermore requires a building permit for every residential EV charger.
Load calc under 200 amps. The city wants a load calculation when the service panel is under 200 amps.
Disconnect over 60 amps. A charger rated over 60 amps needs a disconnect within sight. Any panel upgrade goes on the same plans. Call (925) 241-5744 to start.
Request a Free Quote
Livermore's Permit Center handout says a residential EV charger needs a building permit. We file it, so your charger gets inspected and closed out.
An 8.5 by 11 inch electrical plan with the panel rating and location, the charger load and circuit size, the charging level and the manufacturer cut sheets.
The city asks for a load calculation when the service panel is under 200 amps. It shows whether the charger fits as is, needs load management or needs a bigger service.
The charger mounts at least 18 inches up indoors and 24 inches up outdoors. Anything rated over 60 amps gets a disconnect within sight.
Livermore runs home chargers through its Permit Center with a one-page electrical plan and a checklist. Here is what the city asks for.
Under 200 amps is the line where Livermore wants a load calculation. We run it before we quote, so you know the plan before the permit goes in.
A load management device or a smart panel holds the charger back when the house draws heavy power. It often costs less than a new service and skips the PG&E wait.
Livermore partners with Ava Community Energy on public fast-charging hubs. PG&E delivers the power to your home. Check both for current EV rate plans before you set a charging schedule.
We also handle EV charger installation in Dublin, CA and electrical panel upgrades across the Tri-Valley.